В наличии
APS-XT-GPS
Features and Benefits
- Available as a retrofit to site-installed CommScope and Third Party antennas
- Monitors Azimuth, Tilt, Roll, Latitude, Longitude and Elevation
- Works with AISG 2.1 controllers as an Alignment Sensor Device and Geographic Location Sensor
- Works with AISG 2.0 controllers in RET emulation mode
- Verify Installations
- Long Term Monitoring
- Additional output port for GPS signal (SMA Female connector type)
Характеристики
|
Input Voltage
|
10–30 Vdc |
|
Protocol
|
3GPP/AISG 2.0 compliant |
|
Ширина
|
325 mm | 12.795 in |
|
Глубина
|
166 mm | 6.535 in |
Скачать
ПоделитьсяХарактеристики
|
Input Voltage
|
10–30 Vdc |
|
Protocol
|
3GPP/AISG 2.0 compliant |
|
Ширина
|
325 mm | 12.795 in |
|
Глубина
|
166 mm | 6.535 in |
|
ROHS
|
Compliant |
|
CHINA-ROHS
|
Below maximum concentration value |
|
REACH-SVHC
|
Compliant as per SVHC revision on www.commscope.com/ProductCompliance |
|
Цвет
|
Gray |
|
Масса, нетто
|
1.5 kg | 3.307 lb |
|
ISO 9001:2015
|
Designed, manufactured and/or distributed under this quality management system |
|
CE
|
Compliant with the relevant CE product directives |
|
Operating Temperature
|
-40 °C to +70 °C (-40 °F to +158 °F) |
|
Material Type
|
ASA |
|
AISG Input Connector
|
8-pin DIN Male |
|
AISG Input Connector Quantity
|
1 |
|
AISG Output Connector
|
8-pin DIN Female |
|
AISG Output Connector Quantity
|
1 |
|
Height
|
99 mm | 3.898 in |
|
Electromagnetic Compatibility (EMC)
|
CFR 47 Part 15, Subpart B, Class A | EN 55022 | EN 55032 | EN 61000-4-2 | EN 61000-4-3 | EN 61000-4-4 | EN 61000-4-6 |
|
Interface Protocol Signal
|
RS-485 |
|
Lightning Surge Capability Test Method
|
IEC 61000-4-5 |
|
Lightning Surge Capability Waveform
|
1.2/50 voltage and 8/20 current combination waveform |
|
Lightning Surge Test Mode
|
Common mode |
|
Climatic Sequence Test Method
|
IEC 60068-2-14 |
|
Cold Exposure Test Method
|
IEC 60068-2-1 |
|
Corrosion Test Method
|
IEC 60068-2-11, Test Condition Ka | IEC 60068-2-52, Test Condition Kb |
|
Damp Heat Exposure Test Method
|
IEC 60068-2-30, Test Condition Db |
|
Heat Exposure Test Method
|
IEC 60068-2-2 |
|
Ingress Protection Test Method
|
IEC 60529:2001, IP56 |
|
Packaged Product Shock Test Method
|
ASTM D4169 | GR-63-CORE, Section 4.1.1 |
|
Rain Simulation Test Method
|
IEC 60068-2-18, Test Condition Ra, Method 1 |
|
UV Resistance Test Method
|
IEC 60068-2-5, Test Condition B |
|
Vibration Test Method
|
ASTM D4169 | IEC 60068-2-6 |
|
Azimuth Note
|
Accuracy may be affected by installation environment and satellite visibility |
|
Azimuth, nominal
|
±2.5° |
|
Elevation
|
±5 m |
|
Latitude
|
±5 m |
|
Longitude
|
±5 m |
|
Roll
|
±1° |
|
Tilt
|
±1° |
|
Boot Time
|
15 s |
|
Boot Time Note
|
Exceeds AISG 2.0 and 2.1 requirements |
|
Power Consumption, maximum
|
3 W |
|
Power Supply
|
AISG (compliant with AISG 2.1 ASD and GLS, exceeds AISG 2.0 RET) |
|
Relative Humidity
|
Up to 95%, non-condensing |
|
GPS Output Connector
|
SMA Female |
|
GPS Output Connector Quantity
|
1 |
|
GPS Antenna Gain
|
31±1 dB @ +25 °C (typical) | 31±4 dB @ -40 °C to +70 °C (typical) |
|
GPS Frequency Band
|
1575.42 ±5 MHz |
|
GPS Input Voltage, dc
|
3.8-5.5 Vdc (dual power supply) |
|
GPS Current, dc
|
≤ 30 mA |
|
GPS LNA Output 1dB Compression Point
|
≥0 dBm |
|
GPS Noise Figure
|
1.9 dB typical | 2.5 dB maximum |
|
GPS Out of Band Rejection
|
>35 dB @ 1575 ±50 MHz | >50 dB @ 1575 ±100 MHz |
|
GPS Passband Ripple
|
≤1 dB @ 1575.42 ±1.023 MHz, typical | ≤2 dB @ 1575.42 ±5 MHz, typical |
